We have been preparing for our new counter tops this week (follow me on Instagram stories for live updates!). We will be back with all of the details about our new counter tops next week, but today I wanted to talk about our old laminate counter tops.
Our installers offered us a $150 discount if we removed them ourselves, so you know that we decided to give it the old DIY try. We already painted our old cabinets so we wanted to be sure that we did not damage them!
How to Remove Old Laminate Countertops & Backsplash
Without Damaging the Cabinets
Be sure to check out our whole DIY Coastal Kitchen Makeover!
We had a few steps in our laminate counter top removal process.
How to Remove Laminate Counters
Removing the actual countertops was super simple. They are just screwed in place. If you look inside the cabinet up at the underside of the counter, we had small plastic diagonal pieces in each corner.
These had one screw in them. I used a drill to remove the screws and then the countertops lifted right off – warning – they are heavy!
How to Remove a Laminate “Backsplash”
It took us a little while to figure out what the heck we were doing here so if you are reading this you will be ahead of us.
It helps if you understand this – it appears that our backspash was a 1×4 piece of wood screwed into the wall and then covered with plastic.
So, put your crowbar (or removal tool of choice) in the front seam of the laminate NOT on the seam with the wall. Hopefully this photo makes sense.
Remove just the plastic covering. Now you should see a board with screws. Un-screw them and pop them off the wall. You may need to use a knife to break the seal if it is stuck on with paint around the edges.
Removing the Sink & Faucet
The last step was to remove the sink. We purchased a new sink, faucet, and garbage disposal, so these all had to go. The sink itself had six brackets holding it in place that just needed one screw removed to come away. Then we had to disconnect all the stuff attached to it.
First, we disconnected the disposal, which is as simple as using a screwdriver to give one half twist at the top and it pops off.
Then we had to disconnect the drain pipe on the other side so that now the sink was free.
The last step is to disconnect the two water lines from the faucet. Make sure to turn off the water first.
We actually had to shut off the main water line as well because the connections in this old house don’t completely stop water from pouring out. Then we just pulled the whole thing out as one.
I am SO HAPPY to say bye bye to these laminate countertops. Click here to read all about our new, recycled glass and oyster shell countertops!
This post was last updated on